Safety Instructions - SNDC ECOCLIM SKIMO SPLIT 12V Notice De Montage, De Service Et De Maintenance

List of pictograms used in this manual or on the SKIMO unit
Read and understand the manuel
Important information
•
The kit SKIMO SPLIT must be installed by a person qualified and adequately equipped. All alteration of the unit or
incorrect installation are strictly forbidden and can be dangerous. SNDC SAS cannot be held responsible in the case
of physical or material damages due to an alteration, installation or use that is different to that described in this
manual
•
The SKIMO SPLIT unit weights approximately 30 kg. Take necessary precautions when handling, installing and
using the unit to avoid any risk of injury, fall or damage. Do not handle or install the SKIMO SPLIT unit on your own.
•
Do not store, install or use the kit SKIMO SPLIT close by flammable liquids, gas or solids, or close by a heat source
or in a place presenting risks of explosion or fire.
•
If the kit SKIMO SPLIT is damaged, it must not be used or turned on. It must be repaired or replaced first.
•
If repairs or maintenance operations are required on the kit SKIMO SPLIT, use a qualified company using qualified
personnel to perform the operations. Any repair or maintenance operation that is not done properly can create risks
of danger. Do not try to repair the SKIMO SPLIT by your own means if you are not qualified. For the charge or
maintenance of the A/C refrigerant circuit, use a qualified company that is equipped with appropriate tools and
security equipment and that uses original spare parts.
•
Do dot alter cabins that are certified « FOPS-ROPS »
•
In case of fire, do not open the unit cover. Extinguish the fire with an appropriate fire extinguisher for electrical and
A/C units.
•
Contact the vehicle or machine supplier to enquire of the necessary changes regarding the papers (height of vehicle,
weight...). Perform any necessary changes.
•
Always turn the kit SKIMO SPLIT and the vehicle or machine off before an operation of maintenance.
•
Disconnect all the electrical connections to the machine before fixing, or repairing the kit SKIMO SPLIT or before
any operation that could involve getting in contact with the electrical circuit.
•
Do not introduce foreign objects inside the SKIMO SPLIT unit.
•
The A/C refrigerant circuit is under pressure. Do not open the A/C refrigerant circuit. This would create a loss of
refrigerant gas that is colourless and odourless. It could create serous burns. The personal performing the repair or
maintenance of the A/C refrigerant circuit must be qualified to manipulate such systems and must use appropriate
tools, equipment and protection equipment. Wear protection goggles and gloves when you maintain the SKIMO
SPLIT unit. Rejecting refrigerant gas in the atmosphere is strictly forbidden.
•
The kit SKIMO SPLIT must be maintained and cleaned up regularly from dust, vegetal or other wastes or
combustibles to avoid risks of fire.
•
Use only original spare parts.
•
•
The kit SKIMO SPLIT contains moving parts that represent a danger. Do not disable the security features. Switch
the SKIMO SPLIT unit and the machine or vehicle off before opening the unit or taking the cabin panel off.
•
You must read and understand this manual before proceeding to the installation, set-up, use and maintenance of
the kit SKIMO SPLIT.
SNDC – 274 chemin des Agriès 31860 Labarthe-sur-Lèze – France
Tél : +33 (0)5 34 480 480 - Mail :
EN

Safety instructions

General danger
Physical danger
Caution
– www.sndc.net
sndc@sndc.fr
Eye protection
Protective gloves
p.17