Before Fitting The Skimo A/C Unit; Furniture Required To Install Skimo - SNDC ECOCLIM SKIMO SPLIT 12V Notice De Montage, De Service Et De Maintenance

Table des Matières

Les langues disponibles

Prior to fitting and using the kit SKIMO SPLIT, check the following points :

Cabin volume : Ideally the volume of the cabin is approximately 2m

system will decrease.

Cabin insulation : The cabin walls must be properly insulated, especially from important heat sources (engine, exhaust pipe, hydraulic

system ...). SNDC SAS cannot be held responsible in the case of poor performances of the SKIMO SPLIT system caused by poor

cabin insulation.

Electrical power : The machine or vehicle engine must be equipped with an alternator able to supply the electrical power

required from the vehicle or machine AND from the KIT SKIMO SPLIT. The SKIMO SPLIT system maximal consumption

is 960W. If the vehicle or the machine is equipped with an alternator that is not powerful enough, it must be replaced by

a suitable alternator.

Version

Comsumption

Amperes equivalent

Roof and ceiling : Do not alter or make a hole in the cabin of vehicles that are certified « FOPS-ROPS » The walll must

be stiff and strong enough for the Skimo SPLIT unit to be installed on. If it is not the case, the wall must be reinforced.

The SKIMO SPLIT unit must not be installed if it would affect the stability of the vehicle or machine it is installed on, or if

it would create excessive strains on its structure. Make sure using the drawing showing the dimensions of the unit and

the cut-out area that there is enough space to fit the unit outside on the wall and the vertical evaporator unit n panel

inside the cabin. The surface on which unit is installed must be flat and horizontal (+/- 5°). The cabin panel must be

installed inside the cabin, and the user must be able to access the controls from his driving position while using the

vehicle or machine.

Modèle

SKIMO SPLIT 12 V

SKIMO SPLIT 24 V

SKIMO SPLIT 80 V / 12 V

SKIMO SPLIT 80 V / 24 V

Warning

For electrical connections and converters, see the appendices for references to each unit.

SNDC – 274 chemin des Agriès 31860 Labarthe-sur-Lèze – France

Tél : +33 (0)5 34 480 480 - Mail :