Husqvarna ER 105 Manuel D'utilisation page 12

Maintenance
Examine the bearings. Replace the
bearings if they are worn or damaged.
Replace the bearings.
To clean the product
CAUTION: Do not use a high-pressure
washer to clean the product.
• Use running water from a hose to clean the product.
• Remove concrete from the surfaces of the product
after each operation before the concrete becomes
hard.
To disassemble the product
Note: This instruction is a general procedure. The
procedure is slightly different between the products.
1. Remove the bolts (A) and the washers (B).
C
B
A
2. Remove the end cover (C).
12
Before use, each 10h
3. Remove the bolt (D) and the washer (E).
D
4. Remove the eccentric weights (F).
Note: Make a note of the positions of the eccentric
weights.
5. Remove the screws (G) and the bearing cover (H).
G
6. Remove the bearing (I).
Each 2 weeks, 75h
X
F
E
I
H
Each 4 weeks, 100h
X
1586 - 001 - 26.03.2021