Transport, Entreposage Et Mise Au Rebut; Mise Au Rebut Du Produit - Husqvarna ER 105 Manuel D'utilisation

Problem Cause
The noise lev- The bearings are broken.
el is too high.
The vibration The centrifugal force is too low.
of the concrete
The product is not attached cor-
is not con-
rectly.
stant.
The number of products used is
not sufficient.
The correct product is not used. N/A
The current is The work temperature is too
too high. low.
There is interference between
products.
The product is not attached cor-
rectly.
The centrifugal force is too
high.
The product is too small for the
work.
Transportation
Put the product on a pallet and use a forklift to move it.
Storage
• Clean the product before storage.
• Keep the product in a dry and frost-free area.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.

Mise au rebut du produit

• Respecter les exigences locales en matière de
recyclage et la réglementation en vigueur.
• Lorsqu'on n'utilise plus le produit, l'envoyer à un
détaillant ou le mettre au rebut à un emplacement de
recyclage.
1586 - 001 - 26.03.2021

Transport, entreposage et mise au rebut

Inspection
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
Solution
Replace the bearings.
Adjust the centrifugal force.
Attach the brackets correctly to
the concrete form.
Attach the product with the cor-
rect bolts to the brackets.
Add products where vibration is
missing.
Attach high frequency products
to a vertical concrete form.
Attach lower frequency prod-
ucts to a horizontal concrete
form.
Decrease the centrifugal force
until the temperature increases.
Adjust the positions of the prod-
ucts.
Attach the brackets correctly to
the concrete form.
Attach the product with the cor-
rect bolts to the brackets.
Adjust the centrifugal force.
Replace the product.
69