Connection To The Hydraulic Unit; Threading The Wire - Husqvarna CS 2512 Manuel D'utilisation

Operator's Manual CS 2512

Connection to the hydraulic unit

When the saw is assembled appropriately, it should be
connected to a hydraulic unit. Husqvarna CS 2512 is
designed for use with Husqvarna PP 455 or Husqvarna
RC 455.
1. Check that the hydraulic unit is connected to the power.
2. Connect the cooling water to the motor on the
hydraulic unit.
3. Check that the display on the remote control shows
"CONNECT HOSE BUNDLE". If not follow the instruc-
tions in the Operator's manuals for PP 455E or RC 455.
4. Fit the two large hydraulic hoses on the unit first and
then to the saw motor connections. Lock the couplings
by turning the sleeve on the coupling so that the slot
moves away from the ball.
5. Fit the pressure reduction block on the hydraulic unit as
set out in the instructions on the block.
6. Connect the two smaller hydraulic hoses to the
pressure reduction block. The hoses in the hose
bundle marked with a red disc by the coupling shall be
connected to the hose on the pressure reduction block
that is also fitted with a disc.
Lock the couplings by turning the sleeve on the
coupling so that the slot moves away from the ball.
7. Fit the two hoses connected on the pressure reduction
block to the hoses to the feed cylinder on the saw. The
hoses in the hose bundle marked with a red disc by the
coupling shall be connected to the hose on the saw
that is also fitted with a disc.
8. Connect the water hose to the incoming water on the
saw.
If the couplings jam when assembling, they should be
removed completely before being refitted.
Make sure that the couplings on the hoses not in use do
not lie directly on the ground.
Always keep the couplings as clean as possible. A clean
coupling lasts longer.
Assembling/Installing equipment

Threading the wire

The guard can easily be lifted off to facilitate fitting wire.
Now thread the wire as follows:
1. Make sure the magazine is in the min position.
2. Place the wire around the work piece, possibly through
the predrilled holes and back to the saw.
3. Thread the wire through the hole by the swivel wheel
and around a suitable number of wheel sets in the
magazine.
4. Adjust the drive wheel unit according to the number of
wheel sets used in the magazine:
Loosen the arm by screwing out the knob anti-
clockwise. Now turn the drive wheel unit so that the
arm is aligned with the markings on the saw. Lock the
drive wheel unit by turning back the knob.
Usually only one wheel set is used in the first stage of
cutting.
English - 13