Husqvarna ER 105 Manuel D'utilisation page 63

Remarque : The positions of the eccentric weights
are also found on the inner side of the eccentric
weights covers. The factory positions for the
products are set to position 4.
5. Assemble the product. Refer to
product à la page 66 .
Eccentric weight adjustments for ER
305, ER 405 and ER 505, 50 Hz
1 2
Type, 3000
rpm
ER 305 300
ER 405 540 1630 2730 3820 4910 6000
ER 505 700 2040 3380 4720 6060 7400
Position 1
Eccentric weight adjustments for ER
305, ER 405 and ER 505, 60 Hz
1 2
Type, 3600 rpm
ER 405 170
Position
To adjust the centrifugal force ER 605
and ER 705
1. Remove the bolts and washers that hold the end
To disassemble the product à la
covers. Refer to
page 66 .
2. Remove the end covers.
3. Remove the bolts and the washers from each end of
the rotor.
1586 - 001 - 26.03.2021
To assemble the
3 4 5
Centrifugal force, N
840 1380 1920 2460 3000
2 3 4 5
3 4
Centrifugal force, Lbs
505 840 1175 1510
1 2 3 4
4. Loosen the bolt that attaches the mobile eccentric
weight to the attached eccentric weight. Move the
mobile eccentric weight to adjust the centrifugal
force and tighten the bolt. Refer to
adjustments for ER 605 and ER 705, 50 Hz à la
page 63 and Eccentric weight adjustments for ER
605 and ER 705, 60 Hz à la page 63 .
Remarque : The positions of the eccentric weights
are also found on the inner side of the eccentric
weights covers. The factory positions for the
products are set to position 4.
6
5. Assemble the product. Refer to
product à la page 66 .
Eccentric weight adjustments for ER
605 and ER 705, 50 Hz
6
1
Type,
3000
rpm
ER 605 4500 6000
ER 705 6000 8000 10000 12000 14000 16000
Position
5
Eccentric weight adjustments for ER
605 and ER 705, 60 Hz
5
1
Type,
3600
rpm
ER
1012
605
ER
1435
705
Posi-
tion
MISE EN GARDE : Do the adjustments
on each end of the rotor.
To assemble the
2 3 4
Centrifugal force, N
7500 9000
1 2 3 4
2 3 4
Centrifugal force, Lbs
1350 1687 2025
1913 2391 2869
1 2 3
Eccentric weight
5 6
10500 12000
5 6
5 6
2362 2700
3347 3825
4 5 6
63