Husqvarna ER 105 Manuel D'utilisation page 10

Type,
3600 Centrifugal force, Lbs
rpm
ER
1012 1350
605
ER
1435 1913
705
Posi-
1 2
tion
To adjust the centrifugal force ER
207B, ER 407B and ER 507B
1. Remove the bolts and washers that hold the end
To disassemble the product on
covers. Refer to
page 12 .
2. Remove the end covers.
3. Remove the bolts and the washers from each end of
the rotor.
4. Remove the eccentric weights from the shaft and
turn them 180° to adjust the centrifugal force. Refer
Eccentric weight adjustments for ER 207B, ER
to
407B and ER 507B, 200 Hz on page 10 and
Eccentric weight adjustments for ER 207B, ER 407B
and ER 507B, 180 Hz on page 10 .
CAUTION: Do the adjustments on each
end of the rotor.
Note: The positions of the eccentric weights are also
found on the inner side of the eccentric weights
covers. The factory positions for the products are set
to position 4.
5. Assemble the product. Refer to
product on page 13 .
Eccentric weight adjustments for ER
207B, ER 407B and ER 507B, 200 Hz
1 2 3
Type,
6000
rpm
ER
700 2040 3380
207B
ER
1000 3000 5000
407B
10
1687 2025 2362
2391 2869 3347
3 4 5
To assemble the
4 5
Centrifugal force, N
4720 6050
7000 9000
Type,
6000
rpm
ER
2700 1460 4380 7300 10220 13080 16000
507B
Position
3825
Eccentric weight adjustments for ER
6
207B, ER 407B and ER 507B, 180 Hz
1
Type,
5400 rpm
ER 207B
ER 407B
ER 507B
Position
To reverse the vibration
• Change the positions of the phase wires in the
power supply cable. Refer to
page 21 .
Note: A table with the correct connections is found in
the terminal box.
To do a function check before
operation
1. Assemble the product. Refer to
product on page 13 .
2. Make sure that the product is correctly assembled.
Make sure that the rotor shaft turns freely and is not
loose.
3. Do a check of the motor insulation to ground. Use a
multimeter at 2.2 kV for 5 seconds.
6
4. Make sure that the product is connected to the
correct voltage. Refer to
17 .
5. Do a check with a multimeter that the current is not
more than the value specified on the rating plate.
7400
11000
Centrifugal force, N
1 2 3 4
2 3 4
Centrifugal force, Lbs
120 365 610 855
180 540 540 1260
270 810 1350 1890
1 2 3 4
Wiring diagrams on
To assemble the
Technical data on page
1586 - 001 - 26.03.2021
5 6
5 6
1100 1345
1620 1980
2430 2970
5 6