Important - Antari M-1 Mode D'emploi

Optional Remote Control Operation
There are two optional remote controls designed for the M-1 Mobile Fogger.
1. MCT-1 Timer Remote Control: This remote control is connected via an 8-meter cord. The duration of the
fog blast is set at 10 seconds. The interval is controlled by the dial on the remote and is adjustable between
3 and 220 seconds.
2. MCR-1 Wireless Remote Control: This remote control consists of two components. The transmitter is on a
small key chain and has a range of up to 50 meters from the receiver. The receiver connects to the side of
the M-1 Mobile Fogger and can attach to the M-1's case via a magnetic strip. Pressing the remote control's
button once starts the M-1 fogging. A second press stops the M-1's fog output.
The battery must be removed and the power adaptor unplugged before connecting or disconnecting
Optional Power Adaptor
When desired the M-1 Mobile fogger can be powered by an optional power adaptor which plugs into a standard
electrical outlet. The adaptor connects to a dummy battery which plugs into the battery slot on the M-1. This
allows for unlimited operation of the fog machine. The disadvantage is that a power supply is required and the
mobility of the M-1 is reduced as a result. The advantage is that the machine can fog continuously over an
unlimited period of time.

Important

Always monitor the tank fluid level as you are fogging. Running a fog machine with no fluid can permanently
damage the unit.
A fluid level sensor is installed on the unit. The machine will stop to fog if the fluid is lower than usable level.
When the liquid tank is full and the battery is charged, plug the battery in and press the button on the
handle.
If the machine is still not working and you are unable to determine the cause of the problem, do not continue
pushing the remote button, as this may damage the unit. Do not open the case. There are no user
serviceable parts inside. Return the machine to an ANTARI dealer for service.
Performance Notes
All fog machines develop condensation around the output nozzle. Because this may result in some moisture
accumulation on the surface below the output nozzle, consider this condensation when installing your unit.
Fog machines may sputter small amounts of fog occasionally during operation and for a minute or so after
being turned off. This is normal and is not indicative of a defect.
After continuous operation, the case of the fog machine will become warm, especially at the front of the
machine. Take care in handling the machine during and shortly after fogging. Only carry the M-1 Mobile
Fogger by the handle and let the machine cool down before packing it in a carrying case.
Maintenance
Do not allow the fog liquid to become contaminated. Always replace the cap on the fog liquid container and the
fog machine liquid tank immediately after filling. After every 40 hours of continuous operation, it is
recommended to run a cleaning solution composed of 80% distilled water and 20% acetic acid through the
system to prevent the accumulation of particulate matter in the heating element.
Clean with a dry cloth only. Store dry. Cleaning your fog machine regularly will help reduce costly
either of the remote controls to the M-1 Mobile Fogger.
replacement and repair charges.
WARNING
5