Antari M-1 Mode D'emploi page 4

1. Lift-up the plate before inserting the battery.
2. Make sure the battery is inserted on the right position (see photo).
The green light by the front of the handle will flash when the button is first pressed. This indicates the battery
has enough charge to power the M-1.
When the red light starts to flash, the battery needs to be charged. The machine will still be able to fog for a
short period of time after the red light begins flashing.
Operation
To generate smoke, press the button on the front of the M-1 Mobile Fogger's handle.
There are two operation modes that can be selected for the M-1.
Operation mode 1: Allows the fog machine to fog as long as the handle's button or the remote control's
button is pressed down. To stop fogging, stop pressing the button.
Operation mode 2: Works on a press once to start and press again to stop basis. In this mode, start
fogging by pressing the button. The M-1 will fog continuously until the button is pressed a second time.
Use the small switch on the right side of the M-1. The switch is inside the case and is adjusted through the
small hole on the side of the case.
To select operation mode 1
liquid tank).
To select operation mode 2, slide the switch to wards the front of the M-1 (towards the nozzle).
When an optional remote is connected, please see the detailed instructions for their operation below. The
machine will fog until the battery charge runs down or the M-1 runs out of fog liquid. When the M-1 is
connected to the optional power adaptor, carefully monitor the level of the fog liquid to make sure the
machine does not run out of liquid. Operating continuously, the machine will run out of liquid in
approximately 50 minutes.
A full battery charge will power the M-1 for a period of 10-12 minutes before needing to be recharged. When
using the battery, the charge will run down several times before the fluid needs to be refilled.
Note: There is no warm-up time with the M-1 Mobile Fogger. Unlike most other fog machines, you do not have
to wait for the heater to warm-up before fogging.
Installation
The M-1 Mobile Fogger can be carried by hand or installed in a fixed location as desired.
Wherever the machine is placed, it is important that fog does not shoot directly at any one's face, at open
flames or directly into any heat susceptible material.
The machine can be held or installed at any angle. After refilling the liquid tank, screw the cap on tightly.
Failing to do so will result in leakage if the machine is placed at an angle.
slide the switch towards the back of the M-1 (towards the cap on the
,
4