Adjusting The Airflow Direction - Technibel Climatisation CAFM75R5IA Mode D'emploi

FLAPS
Setting the airflow direction
To activate the swing
operation
Heating
Set the flap (vertical airflow flap) to the downward
position. If the flap is set to the upward position,
the warm air may not reach the floor.
Initial setting
To stop the swing operation

Adjusting the Airflow Direction

• Never use your hands to move the flap (vertical airflow flap) that is
controlled using the remote control unit.
• When the air conditioner is turned off, the flap (vertical airflow flap)
automatically moves to the downward position.
• The flap (vertical airflow flap) moves to the upward position when
performing the standby operation for heating. The swing operation is
made after the standby operation for heating is released, but swing is
indicated on the remote control unit even during the standby operation for
heating.
The airflow direction changes each time the
during operation.
Press the FLAP button to set the flap (vertical airflow flap) to the downward
position, and then press the FLAP button again. This displays
airflow automatically swings up and down.
Cooling and drying
The flap (vertical airflow flap) can
be set to one of three positions.
Initial setting
Press the FLAP button again during the flap swing operation to stop the flap
at the desired position. Then, the airflow can be set from the top position by
pressing the FLAP button again.
Indicator when swing operation is stopped
Fan and heating
During cooling or drying operation, the flap will not stop at the downward
position. Even if the flap is stopped at the downward position during the swing
operation, it will not stop until it moves to the third position from the top.
FLAP button is pressed
Fan operation
Initial setting
Cooling and drying
, and the
All operations
Continuous
operation
23