Technibel Climatisation CAFM75R5IA Mode D'emploi page 19

J: TIMER SET button
(OFF Timer)
(OFF Cycle Timer)
(ON Timer)
K: Time setting buttons
L: SET button
M: CL button
N: VENTILATION button
O: Remote control sensor
Parts Name and Functions (continued)
Use this button while the unit is operating to switch between timer settings.
: The air conditioner stops after a preset time elapses.
:The air conditioner always stops after a preset time elapses.
: The air conditioner starts after a preset time elapses.
: Press this button to increase the time.
: Press this button to decrease the time.
Use this button to set the timer.
Use this button to clear the timer setting.
This is used when a ventilation fan (available commercially) is connected.
Pressing the VENTILATION button turns the fan on and off. The ventilation
fan also turns on and off when the air conditioner unit is turned on and off.
(The display of the remote control unit shows "
is running.)
* If " " is shown on the display of the remote control unit when the
VENTILATION button is pressed, this indicates that the ventilation fan is
not connected.
Normally, the temperature sensor of the indoor unit is used to detect the
temperature. However, it is also possible to detect the temperature around
the remote control unit.
For details, contact the dealer where you made the purchase.
(Do not set when using group control.)
1) When two remote control units are being used in one group control*
NOTE
system,
a) the most recent button that is pressed on any remote control unit is
effective.
b) either a main-remote control unit or a sub-remote control can set the
timer.
* Group control means that maximum up to 8 indoor units can be
concurrently controlled with a remote control unit.
2) If a power failure occurs in timer mode, the time counted up to that point
will be stored in memory.
After power is restored, the timer starts again counting up to the set time.
" while the ventilation fan
19