Adjusting The Air Flow Direction; Operation Without The Remote Control Unit - Technibel Climatisation MAV 184 C Notice D'utilisation

TIMER SETTING PROCEDURE.
• Press the 1 HR TIMER button. The 1-HOUR ON TIMER mark
will appear on the display .
1-HOUR TIMER cancellation procedure.
• Press the ON/OFF button to turn the air conditioner off.
• Wait for the indoor unit to stop operating.
• Press the ON/OFF button again to turn the air conditioner on.
DISPLAY AFTER THE SETTING OPERATION
NOTES
• If the 1-HOUR TIMER button is pressed after a certain time
is elapsed from the setting operation, the 1-HOUR timer
function is activated again.
COMBINING THE 1-HOUR TIMER AND THE DAILY PROGRAM
• The 1-hour timer can be activated after the daily program
setting (par. C).
• If the 1-HR TIME is pressed with the TIMER set in OFF
( sign on the display) this setting will be cancelled as
the 1-HOUR TIMER is activated, the air conditioner runs for
1 hour and then it stops.

ADJUSTING THE AIR FLOW DIRECTION

HORIZONTAL (manual)
The horizontal air flow can be adjusted by moving the vertical
vanes to the left or right, as indicated in the following figures for
each model.
VERTICAL (with remote control unit)
Make sure that the remote control unit has been turned on. Press
the FLAP button to start the flap moving up and down. If you want
to stop the flap movement and to direct the air in the desired
direction, press the FLAP button again.
CAUTION
Set vertical vanes to the front position during COOLING/DRY
operation if humidity is high.
If the vertical vanes are set to the left-most or right-most
position, condensation will form around the air outlet and
drip off.
CAUTION
Do not move the flap with your hands when the air conditioner
is running.
MAVxxx MODELS
VERTICAL
VANE
HOW TO ADJUST THE FLAP DIRECTION MAVxxx MODELS
Zone «A»
for cooling and dehumidifyng
KPAxxx MODELS
VERTICAL VANE
HOW TO ADJUST THE FLAP DIRECTION KPAxxx MODELS
« A »
« B »
Zone «A»
for cooling and dehumidifyng
OPERATION WITHOUT THE REMOTE
CONTROL UNIT
If you have lost the remote control unit or it has troubles, follow
the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner, switch the operation
selector to the OFF position, and then to the ON position.
NOTE
The set temperature, and fan speed are automatically set at
the last selection before stopping.
FLAP
9
EG
Zone «B»
for heating
FLAP
« A »
« B »
40°
Zone «B»
for heating