Setting The 1 Hour Timer; Adjusting The Air Flow Direction - Technibel Climatisation MRAF98C5T Série Manuel D'utilisation

SETTING THE 1 HOUR TIMER

This function causes the unit to operate for one hour at the
set conditions, regardless of whether the unit is on or off.
TIMER SETTING PROCEDURE.
● Press four times the TIMER SEL
button.The 1 HOUR TIMER mark will
appear on the display.
CANCELLATION PROCEDURE
● Press the ON/OFF button to turn the air conditioner off.
GB
● Wait for the indoor unit to stop operating.
Press the ON/OFF button again to turn the air conditioner
●
on.

ADJUSTING THE AIR FLOW DIRECTION

HORIZONTAL (manual) - Only for MRAF-MPAF-KPAF
models
The horizontal air flow can be adjusted by moving the
vertical vanes to the left or right, as indicated in the following
figures.
MRAF-MPAF MODELS
Vertical vane
KPAF MODELS
VERTICAL VANE
VERTICAL (with remote control unit)
Press the FLAP button to select the flap function:
Fixed:
six
position
Right
Left
Continous Automatically
oscillations oscillations
The flap automatically closes when the unit
●
NOTES
is off.
When the unit starts in heating operation,
●
4
the fan speed will be low and the flap will be
in the
out of the unit begins to warm. Once the air
warms up, the flap position and fan speed
change to the settings specified with the
remote control.
CAUTION
Do not move the flap with your hands when the air
conditioner is running.
CAUTION
●
Use the FLAP button on the remote control to adjust
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
●
Do not have the flap pointed down during cooling
operation. Condensation may begin to form around the
air vent and drip down.
MRAF-MPAF MODELS
Air outlet
grille
KPAF MODELS
CAF MODELS
FLAPS
8
position until the air being blown
Up
Flap
Down
DEFLETTORE