Lighting The Main Burner And Regulating The Temperature; Putting Out The Main Burner; Turning Off The Appliance; Emptying The Water Container - Lotus BMT-64G Instructions Pour L'installation Et L'emploi

the thermocouple to warm up, then release it. The flame may go out, in which case it is necessary to repeat the
procedure.

Lighting the main burner and regulating the temperature

After releasing the knob, the gas goes into the safety valve.
Turning the graduated knob from 30 a to 90° C, the gas flows to the main burner which then lights.

Putting out the main burner

Turn the knob into position

Turning off the appliance

Push and turn the knob into position "0". This command blocks the gas supply to both the main burner and the pilot
burner.
Turn the drainage tap from the "off" position to "on".
NB: it is recommended to carry out this operation using water which is not too hot.

INSTRUCTIONS FOR DISCHARGING GAS EMISSIONS

Type "A" Appliances (See data plate)

Type "A" appliances must discharge the products of combustion through extractor hoods or similar devices connected
to an efficient chimney, or directly outside. (Natural Discharge) Fig.1.
If there is no hood, as an alternative, an air extractor connected directly to the outside is acceptable, (Forced
Discharge) Fig.2, but its capacity must not be inferior to what is established in item 4.3 of the UNI-CIG norm 8723.

In the event of forced discharge

The gas supply to the appliance, must be directly interlocked to the system and must cut off automatically if its capacity
drops below the values prescribed by item 4.3 of the UNI-CIG norm 8723.
Supplying the appliance with gas again must only be possible manually.
NATURAL DISCHARGE Fig. 1
1) Extractor hood
Always keep the water level checked.
Attention! Do not start up the appliance without water.
Use the appliance only under surveillance.
Daily cleaning after switching off the appliance ensures the perfect functioning and long life of the appliance.
GB
IT
; only the flame of the pilot burner remains lit.

EMPTYING THE WATER CONTAINER

OBSERVATIONS AND ADVICE

CLEANING AND MAINTENANCE

IE
CH
FORCED DISCHARGE Fig. 2
1) Extractor hood
2) Interlocking
28