Maintenance; Spare Parts; Instructions For Use; Lighting The Main Burner - Lotus F13-74G Instructions Pour L'installation Et L'emploi

With prolonged use of the appliance, it is essential to carry out regular maintenance for the safe functioning of the
appliance; we therefore recommend drawing up a contract for after sales service.
Maintenance must be done only by specialized personnel, observing the norms in force and our indications.

Spare parts

It is possible to substitute parts such as the valve, the piezoelectric lighter or gas pipes very simply. To substitute the
parts, proceed as follows:
• Valve: after removing the front panel, unscrew the screwed fittings (5-7-8-14) of the gas connections and take out
the thermostat bulb, then substitute the faulty parts, installing the new ones.
• To substitute the thermocouple, unscrew the pilot burner fitting, likewise the valve fitting and substitute the
element.
• The spark plug must be unscrewed and substituted.
Attention!
Before lighting the appliance, it is necessary to wash it with water and washing-up liquid, rinse thoroughly and fill with
oil up to the level marked on the back of the container.

Lighting the pilot burner

Push down and turn the thermostat knob into position
repeatedly. The flame lights automatically and can be seen through the inspection hole in the front panel. After lighting,
hold the knob down for another 5-10 seconds, to allow the thermocouple to warm up, then release it. The flame may go
out, in which case it is necessary to repeat the procedure.

Lighting the main burner and regulating the temperature

After releasing the knob, the gas goes into the safety valve.
Turning the graduated knob from 110 a to 190° C, the gas flows to the main burner which then lights.

Putting out the main burner

Turn the knob into position
Push and turn the knob into position "0". This command blocks the gas supply to both the main burner and the pilot
burner.

Safety thermostat

The appliance is provided with a safety thermostat which interrupts the gas flow if the temperature of the oil goes above
the maximum set value (230°C). When the safety device intervenes, both the main burner and pilot burner go out.
If this happens, it is possible to restart by pressing down fully the red thermostat button after having removed the
control panel. If the problem occurs again, call in the after sales assistance.
To carry out this operation, it is necessary to open the outlet tap which can only be reached through the cabinet door
situated below. Before doing this, check that the filter and the oil collecting container are in the correct position.
NB: It is advisable not to do this when the oil is too hot.
The user is to have a suitable container for the emptying of the oil. This container must be made of heat resistant
material and must be constructed so that during the emptying the oil does not overflow and is not dangerous. We
recommended filtering the oil daily at the end of the working day and change the oil when necessary.
Insert the drain pipe according to the diagram and position the container.
Push the safety device against accidental openings upwards and bring the lever towards the symbol

INSTRUCTIONS FOR DISCHARGING GAS EMISSIONS

Type "A" Appliances (See Data plate)

Type "A" appliances must discharge the products of combustion into extractor hoods or similar devices connected to
and efficient chimney, or directly outside. (Natural Discharge) Fig.1.
IT
GB

MAINTENANCE

INSTRUCTIONS FOR USE

LIGHTING THE MAIN BURNER

;only the flame of the pilot burner remains lit.

TURNING OFF THE APPLIANCE

EMPTYING THE TUB MOD. F...

EMPTYING THE TUB MOD. F...T
35
CH
IE
. Keep the knob pushed down, then press the piezo button