Transmitter Settings - Thomas CentraClean 15-301 Instructions D'installation Et De Service

Masquer les pouces Voir aussi pour CentraClean 15-301:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20

3.3 Transmitter settings

3.3.1 Teaching-in radio transmitter
To operate with the radio control, the system must be programmed
to a radio transmitter.
– For this the integrated transmitter within the tube bend is exactly as shown,
to be kept close to the hood of the system.
to be kept close at the bottom left on the receiver unit.
– Press one of the two sender keys ( or
display.
– Take away the sender/receiver unit from the system and repeat from
a distance of approx. 1 metre and press one of the two sender keys again
(within 60 seconds). Shown on the LCD is
{
Only after the
OK display goes of after 3 seconds the sender has been
teached-in and the system can be started via the key.
3.3.1.1 Teaching-in radio transmitter – faulty operation
{
LN01 will appear for 1 second on the LCD in case of faulty operation the time window of 60 seconds be exceeded
and the learn function has not been correctly implemented. After this
dure repeats itself up to 10 times. Afterwards
initial installation.
The basic display will appear on the LCD in the case of already learned in senders
– The learn procedure is to be repeated.
3.3.2 Clearing the sender
If just one sender is cleared all teached-in radio transmitter or repeater will be deleted.
– To delete the transmitter hold the transmitter to the given position at the system, see figure above.
– Press sender
key and hold down for 5 seconds. Do not take away the transmitter from the system!
appear for 2 seconds on the LCD, followed by
signal from the system.
{
{
FFB and
OPEN will now be displayed alternately on the LCD.
Now new senders can be teached-in in again.
3.3.2.1 Clearing the sender – faulty operation
In the case of faulty operation, for example, when the sender key is held down for longer than 2 seconds, but for
{
less than 5 seconds,
CLR will appear on the LCD for 1 second followed by
repeats itself up to10 times, after which the basic display will appear on the LCD.
By pressing one of the two keys on the transmitter the faulty delete operation will be interrupted and a new attempt
can be started.
3.4 Control cable connection
Pull out the contact plug of the control cable plug box. Then connect the on-site control line wires with the connec-
tor and insert and fix the control line socket.
14
{
) and
LERN appears on the LCD
{
LN01 for 1 second.
{
{
FFB and
OPEN will appear alternately on the LCD in the case of
{
CLR for 3 seconds.
{
FAIL will appear for 3 seconds. This proce-
{
OK will appear for 2 seconds as return
{
FAIL for 3 seconds. This process
{
LERN will

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Centraclean 18-451Centraclean 34-451

Table des Matières