Thomas CentraClean 15-301 Instructions D'installation Et De Service page 12

2. Installation of the central vacuuming system
2.1 Installation of central vacuum cleaner
Mounting the unit
• Mount vibration decoupler
• Fasten the wall holder with screws
dowels (height approx. 1.6 m, see planning brochure).
• Fit distance piece
at a distance x.
Model
15-301
15-301 PowerControl
18-451 PowerControl
34-451
• Connect up appliance to power supply, see Point 3.0
• Hang up appliance.
p
Filter system
All THOMAS central vacuum cleaning systems are equipped with a long-term cartridge filter and in addition operate
on a cyclone filter principle.
Assembling cartridge filter
The cartridge filter is prefitted at the factory. Please check that the cartridge filter is firmly fitted before starting to
use the cleaner.
Important
Under no circumstances is the system to be operated without cartridge filter or when the cartridge
filter is damaged.
The exhaust air system must be connected.
No foreign objects must be allowed to get into the exhaust air system.
12
into the wall holder
, washers
centric under the wall holder
Distance x
17 cm
17 cm
33 cm
To connect suction line
• Insert suction line (HT-DN 50) to the con-
nector (left or right).
Note:
Direct connection to the vacuum cleaner
with double socket (sliding socket).
• Lock up the not needed connection pipe
sokcet with plugs (included in delivery).
DN 50
Note:
The suction lines can be connected up to the left and right where two rising lines are used.
Connect exhaust line
• Insert blow-off line (HT-DN 70) to the exhaust connection.
• System 34-451 must be connected to two exhaust lines (see also planning brochure)
• Fit the blow-off flap on the wall duct allaring the exhaust air to escape, see also planning
brochure.
.
and