Important Safety Information; Safety Instructions - Enphase Energy M215 Manuel D'installation Et D'utilisation

Important Safety Information

Read this Before Installing or Using the M215
This manual contains important instructions for use during installation and
maintenance of the Enphase M215™ Microinverter. User documentation is updated
frequently; Check the Enphase website (http://www.enphase.com/support/downloads)
for the latest information.
To reduce the risk of electrical shock, and to ensure the safe installation and
operation of the Enphase Microinverter, the following safety symbols appear
throughout this document to indicate dangerous conditions and important safety
instructions.
WARNING! This indicates a situation where failure to follow instructions may
be a safety hazard or cause equipment malfunction. Use extreme caution and
follow instructions carefully.
NOTE: This indicates information particularly important for optimal system
operation. Follow instructions closely.

Safety Instructions

Perform all electrical installations in accordance with all applicable local electrical

standards.
Be aware that only qualified personnel should install or replace Enphase Microinverters.

Do not attempt to repair the Enphase Microinverter; it contains no user-serviceable

parts. If it fails, please contact Enphase customer service to obtain an RMA (return
merchandise authorization) number and start the replacement process. Tampering with
or opening the Enphase Microinverter will void the warranty.
Before installing or using the Enphase Microinverter, please read all instructions and

cautionary markings in the technical description and on the Enphase Microinverter
System and the PV equipment.
Connect the Enphase Microinverter to the utility grid only after receiving prior approval

from the electrical utility company.
Be aware that the body of the Enphase Microinverter is the heat sink. Under normal

operating conditions, the temperature is 15°C above ambient, but under extreme
conditions the microinverter can reach a temperature of 80°C. To reduce risk of burns,
use caution when working with microinverters.
Do NOT disconnect the PV module from the Enphase Microinverter without first

removing AC power.