Important Safety Information; Read This Before Installing Or Using The M215; Safety Instructions - Enphase Energy M215 Manuel D'installation Et D'utilisation

Important Safety Information

Read this Before Installing or Using the M215

This manual contains important instructions for use during installation
and maintenance of the Enphase M215™ Microinverter. User
documentation is updated frequently; Check the Enphase website
(http://www.enphase.com/support/downloads) for the latest information.
To reduce the risk of electrical shock, and to ensure the safe installation
and operation of the Enphase Microinverter, the following safety symbols
appear throughout this document to indicate dangerous conditions and
important safety instructions.
WARNING! This indicates a situation where failure to follow instructions
may be a safety hazard or cause equipment malfunction. Use extreme
caution and follow instructions carefully.
NOTE: This indicates information particularly important for optimal
system operation. Follow instructions closely.

Safety Instructions

Perform all electrical installations in accordance with all applicable local

electrical standards.
Be aware that only qualified personnel should install or replace Enphase

Microinverters.
Do not attempt to repair the Enphase Microinverter; it contains no user-

serviceable parts. If it fails, please contact Enphase customer service to
obtain an RMA (return merchandise authorization) number and start the
replacement process. Tampering with or opening the Enphase Microinverter
will void the warranty.
Before installing or using the Enphase Microinverter, please read all

instructions and cautionary markings in the technical description and on the
Enphase Microinverter System and the PV equipment.
Connect the Enphase Microinverter to the utility grid only after receiving prior

approval from the electrical utility company.
Be aware that the body of the Enphase Microinverter is the heat sink. Under

normal operating conditions, the temperature is 15°C above ambient, but
under extreme conditions the microinverter can reach a temperature of 80°C.
To reduce risk of burns, use caution when working with microinverters.
Do NOT disconnect the PV module from the Enphase Microinverter without

first removing AC power.
Page 5 Copyright Enphase Energy Inc. 2011
e
n
g
l
i
s
h
141-00017, Rev 01