Fcc Information - Sigma PC 26.14 Guide Rapide

FCC Information

Subpart 15A Rule Section 15.19(a)(3) requires the label of the device include
the followingstatement, or where the label/equipment is too small, then the user
information can contain the following statement:
"This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation."
Subpart 15A Rule Section 15.21 requires the following:
The users manual or instruction manual for an intentional or unintentional
radiator shall caution the user that "Changes or modifications not expressly
approved by the party responsible for compliance couldvoid the user's authority
to operate the equipment."
Subpart 15B Rule section 15.105 requires the following to be included in the
user information:
"NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver isconnected.
— Consult the dealer or an experienced radio/TV technician for help."
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference,
and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
90