Extent Of Delivery; Josef-Drexler-Str. 8, 89331 Burgau - Germany - ATIKA T 250 N-2 Notice Originale

Do not operate machine before having read
the operating instructions, understood all the
notes and assembly the machine as described
here.
Keep the instructions in a safe place for future use.
Contents

Extent of delivery

Declaration of conformity
Characteristics data of noise
Symbols machine /operating instructions
Normal intended use
Residual risks
Safety instructions
Description of device / Spare parts
Assembly
Preparing for commissioning
Commissioning
Mains connection
On / Off Switch
Dust/chip exhaustion
Adjusting the saw
Adjusting the riving knife
Set the cutting height
Adjust saw blade pitch
Fitting and adjusting the transverse stop
Fitting and adjusting the longitudinal stop
Working instructions
Cutting narrow workpieces
Cutting wide workpieces
Cross cuts / mitre cuts
Maintenance and care
Maintenance
Cleaning
Transport
Storage
Possible faults
Technical data
Guarantee
Extent of delivery
After unpacking, check the contents of the box
That it is complete
Check for possible transport damage
Report any damage or missing items to your dealer, supplier or
the manufacturer immediately. Complaints made at a later date
will not be acknowledged.
• Circular saw T 250 N-2 including
− Power cable and plug
− TCT saw blade ∅ 250 x 1,8/2,8 x ∅ 30 mm; 40 teeth
− Splitting wedge
• 4 table legs
• 2 connecting braces short
• 2 connecting braces long
• 4 push-on bases
• 2 additional braces
11
• Safety guard with exhaust outlet
11
• Longitudinal stop
12
• Table length extension
12 • 2 supports for bench length extension
• 2 bench width extensions
12
• 4 supports for table width extensions
13
• Pushstick
13
• Extraction hose
15
• screw bag
15
• 2 spanners for replacing saw blade
15
• Operating manual
16
• Assembly and operating instruction sheet
16
• Warranty declaration
16
16
16
EC Declaration of Conformity
16
17
No. (S-No.): 16208
17
according to EC directive: 2006/42/EC
17
We,
17
ATIKA GmbH
17
Josef-Drexler-Str. 8
89331 Burgau - Germany
17
17
herewith declare under our sole responsibility that the product
Tischkreissäge (Circular Saw Bench)
18
Model M1H-ZP2-1-250A, Type T 250 N-2
18
18
Serial number: 000001 - 020000
18
is conform with the above mentioned EC directives as well as with
19
the provisions of the guidelines below:
2004/108/EC and 2011/65/EU
19
19
Following harmonized standards have been applied:
EN 61029-1:2009/A11:2010; EN 61029-2-1:2012;
20
EN 55014-1:2006/A2:2011; EN 55014-2:1997/A2:2008;
20
EN 61000-3-2:2014; EN 61000-3-3:2013
Duly authorised person for the complilation of technical
documents:
ATIKA GmbH - Technical department
Josef-Drexler-Str. 8 - 89331 Burgau - Germany
Burgau, 18.12.2015
i.A.
i.A. G. Koppenstein,
Engineering design management
11