Reely Audi RS5 Notice D'emploi page 38

The following figures are only to illustrate the functions and do not necessarily correspond to the design of
the transmitter provided!
1. Release throttle/braking lever, vehicle rolls to a halt (or does not move, if required, correct trimming), lever is in
neutral position
2. Drive forwards, slowly pull the throttle/brake lever towards the handle

3. Drive forwards and then brake (vehicle slows down; it does not roll to a halt slowly); push throttle/brake lever away
from the handle without stopping

4. Drive forwards and then go into reverse (wait briefly between the change (approx. 1 - 2 seconds) and leave the
lever in its neutral position!)

If the neutral position is not correct (e.g. trimming control slightly off), you cannot switch between forward
and reverse driving. If you have this problem, correct the trimming settings for the driving function at the
transmitter.
Please observe that the speed controller recognises the current position of the throttle/brake lever at the
transmitter (or additionally the trimming for the driving function) as neutral position after switching on!
38
Wait briefly