Before Using The Appliance; Lighting The Burners - Pelgrim GKB 210 Notice D'utilisation

Table of contents
Appliance information . . . . . . . . . . . . . . . .8
Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Before using the appliance . . . . . . . . . . . . .9
Things to watch for . . . . . . . . . . . . . . . . . . .9
Operating the appliance . . . . . . . . . . . . . .10

Lighting the burners . . . . . . . . . . . . . . . . . .10

Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
Saucepans . . . . . . . . . . . . . . . . . . . . . . . . .10
Maintenance . . . . . . . . . . . . . . . . . . . . . . .11
Cleaning the appliance . . . . . . . . . . . . . . .11
Installation . . . . . . . . . . . . . . . . . . . . . . . . .12
Positioning . . . . . . . . . . . . . . . . . . . . . . . . .13
Technical specifications . . . . . . . . . . . . . .13
Appliance information A, B, C and D
(fig. 1, 2, 3)
A - standard burner
B - high-speed burner
C - low-speed burner
1 - control knob for burner right front
2 - control knob for burner left front
3 - control knob for burner left rear
4 - control knob for standard right rear
5 - spark switch
6 - control knob for burner centre front
7 - control knob for burner centre rear
1e proef 10-05-96
Introduction
When you have read these instructions for
use, you will quickly be aware of all the
facilities the appliance can offer you. You can
read about safety and how you should look
after the appliance. In addition you will find
environmental tips and instructions that can
help to save energy.
Keep the instructions for use and the
installation instructions. Any later user of this
appliance could benefit from them.
Enjoy your cooking!
Control knob symbols:
0 off
high
low
This appliance complies the regulations concerning
electromagnetic compatibility in directive 89/336/EEC.

Before using the appliance

The fitting of the appliance should only be
carried out by a registered Corgi gas fitter.
During repair and cleaning the appliance
needs to be disconnected from the power
supply (electricity and gas). Remove the
plug from the wall socket or turn the switch
in the metre cupboard to zero (for gas hobs
with a spark switch). Turn off the gas tap in
the feeder pipe.
This cooking appliance is designed for
household use. It should only be used for
preparing meals.
When boiling and frying the hob gets hot.
Please pay close attention to small
children.
Grease and oil are flammable when over-
heated. Stay near the appliance when
preparing dishes.
Do not use the appliance to heat the
kitchen. This will produce a damp
atmosphere.
When a gas cooking appliance is being
used heat and moisture is produced in the
area where the appliance is situated. Make
sure that the area is sufficiently ventilated;
open natural ventilation openings or fit a
mechanical ventilator (extractor). When the
hob is used for longer periods extra
ventilation may be needed, such as an open
window or a higher setting on the ventilator
(extractor).
Things to watch for
Clean immediately
Any spillage should be removed immedia-
tely, particularly red cabbage, apple sauce
and rhubarb. These can leave permanent
spots on the enamel or on stainless steel.
Burning in of the enamel
The burners cause the saucepan supports
to get extremely hot. Over time the enamel
on the support points can burn in. This
cannot be prevented and is not covered by
the guarantee.
Burner caps
Check regularly to ensure that the caps of
the burners are properly in position on the
burner depressions; improper positioning
can make it difficult to light the burners,
give rise to an irregular gas flame, or
damage the burner caps.
Lighting the burners
While keeping the knob of the burner held in,
turn the knob to the left and light the burner
with a match. The gas flame can now be
smoothly adjusted from high to low.
Using the electrical spark switch if present)
Press the knob of burner in and turn it to the
left to the -symbol. The spark switch will
generate sparks and the burner will light
automatically. If the burner fails to light after
repeated attempts, check to ensure that the
burner cap is properly positioned. The gas
flame can now be smoothly adjusted from high
to low.