Overview; Cooktop Burners - La Cornue AlberTine 90 Mode D'emploi

2. Overview

Cooktop Burners

Before using the cooktop make sure all burners are in place
and all the pan supports on the cooker are properly placed.
The drawing by each knob indicates which burner that knob
controls (Fig.2-1).
Each burner has a Flame Supervision Device (FSD) that stops
the ow of gas if the ame goes out. Push in and turn a knob
to the '' lighting position (Fig.2-2).
Keep holding the knob pressed in to let the gas through to
the burner for about 4 seconds (Fig.2-3). The igniter should
spark and light the gas. When a cooktop burner knob is
pressed in, sparks will be made at every burner – this is
normal. Do not attempt to disassemble or clean around any
burner while another burner is on. An electric shock could
result.
If, when you let go of the control knob, the burner goes out,
the safety device has not held in. Turn the control to the
OFF position and wait one minute, then try again this time
holding in the control knob for slightly longer.
Adjust the ame height to suit by turning the knob. On this
cooker the low position is beyond high, not between high
and o . The ' ' marks the low position.
ArtNo.280-0003 110 Hotplate USA
3
ArtNo.280-0101 - Knob Press In EU
English
Fig.2-1
Fig.2-2
Fig.2-3