Final Fitting - La Cornue AlberTine 90 Mode D'emploi

Check the appliance is electrically safe and gas sound when you have nished.
Fig.7-20
ArtNo.280-0044 Cornufe Knobs 5
ArtNo.280-0045 Burner Knob
Fig.7-21
ArtNo.280-0046 Burner Knob 2
ArtNo.280-0047 Oven Knob
Fig.7-22
Fig.7-23
ArtNo.280-0051 Handrail Fitting Endcaps C
Fig.7-24
ArtNo.280-0053 Door Knob Screw to Door
Fig.7-25
ArtNo.281-0026 - Front plinth
INSTALLATION

Final Fitting

Installing the Control Knobs
The cooker is supplied with 5 burner control knobs. These are
for the gas controls to the left of the control panel (Fig.7-20).
There are also 2 oven control knobs (Fig.7-21).
Push the multi-function oven selector knob and temperature
knob on to the control spindles at the right-hand side of the
control panel.
Installing the Handrail
The handrail is supplied as 2 end pieces with grub screws,
2 plastic friction cups and the rail tube (Fig.7-22).
Hold a friction cup by the tabs on one end of the tube. Fit one
of the end pieces to the tube and push it on the tube over the
friction cup (Fig.7-23).
Turn the tube over and t the other end piece using the
second friction cup, making sure that you do not scratch or
damage the rst end piece and the that the two end pieces
are lined up correctly.
Fit the assembled handrail to the projecting mounting studs
on the control panel and x it in place by tightening the grub
screws. The grub screws should be on the underside.
Installing the Door Handle
Assemble the door knob to the door knob base and screw it
to the mounting on the oven door. Hand tighten only – DO
NOT use any tools (Fig.7-24).
Fitting the Plinth
Remove the 3 screws for the plinth mounts along the front
bottom edge of the range (Fig.7-25). Fasten the plinth using
these screws (alternative colour screws can be found in the
loose parts pack).
26