Check the appliance is electrically safe and gas sound when you have nished.
Refitting the Drawer
Slide the inner side rails out until fully extended (Fig.7-26).
Lift the drawer at its sides and locate one of the drawer rails
(approximately 15 mm) onto an inner side rail (Fig.7-27).
Rotate the drawer to locate the remaining drawer rail onto
the opposite inner side rail.
Carefully slide the drawer back into the cavity. Some
resistance will be felt as the drawer rails locate fully onto the
inner side rails.
Refitting the Oven Door
To re t the door, slide the hinges back into their slots. Rotate
the locking 'U' clips back to t onto the hinges.
Cooker Operational Checks
Hotplate Check
Check each burner in turn. There is a ame supervision device
(FSD) that stops the ow of gas to the burner if the ame
goes out. For each burner, turn the control knob to the ''
ame symbol. Press in the control knob. This lets gas through
to the burner. Keep holding the knob pressed in and press
the igniter button or light with a match. Keep holding the
control knob pressed in for about 10 seconds.
If when you let go of the control knob the burner goes out,
the safety device has not held in. Wait one minute then try
again this time holding the control pressed in for slightly
longer.
Oven Check
Turn on the oven and check that it starts to heat up. Check
that the oven lights are working.
Note: The oven light bulb is not included in the guarantee.
Turn o the oven.
Customer Care
Installer: Please complete your details in this Guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
INSTALLATION
Make sure the inner
rail is forwards
27
15 mm
Approx.
Fig.7-26
Fig.7-27