Checking The Parts; Location Of Cooker; Conversion - La Cornue AlberTine 90 Mode D'emploi

Check the appliance is electrically safe and gas sound when you have nished.

Checking the Parts:

Allen keys
1x full capacity grill tray with
cradle
3x energy saving shelves
Plinth
ArtNo.350-0008 - 90 SC plinth
INSTALLATION
1x full capacity telescopic shelf
with runners
1x pastry tray
ArtNo.326-0005 - Pastry tray
Divider
ArtNo.281-0028 - Albertine divider
Side extension kit
ArtNo.351-0001 - Side extension
panel USA

Location of Cooker

The cooker may be installed in a kitchen/kitchen diner but
NOT in a room containing a bath or shower.
Note: An appliance for use on LPG must not be installed
in a room or internal space below ground level, e.g. in a
basement.

Conversion

All models are supplied set for use on group H natural gas.
A conversion kit for LP gas is included with the appliance.
See the instructions that are supplied with the conversion
kit. After converting the appliance, please attach the Gas
Conversion sticker over the appropriate area of the data
badge – this will identify the gas type for which the appliance
is now set.
You will need the following equipment to complete the
cooker installation satisfactorily:
• Stability bracket: If the cooker is to be supplied with gas
through a flexible hose, a stability bracket or chain must
be fitted.
These are not supplied with the cooker but are
available at most builders' merchants.
• Gas pressure tester/manometer.
• Flexible gas hose: Must be in accordance with the
relevant standards.
• Multimeter: For electrical checks.
You will also need the following tools:
1.
Electric drill
2.
Masonry drill bit (only required if tting the cooker on a
stone or concrete oor)
3.
Wall plugs (only required if tting the cooker on a stone
or concrete oor)
4.
Steel tape measure
5.
Cross head screwdriver
6.
Flat head screwdriver
7.
4 mm & 3 mm Allen keys
8.
Spirit level
9.
Pencil
10.
Adjustable spanner
11.
13 mm spanner or socket wrench
20