Technical Service; General Warnings - Hendi 225516 Mode D'emploi

Dear Customer,
Thank you for purchasing this Hendi appliance. Please read this manual carefully before connecting the
appliance in order to prevent damage due to incorrect use. Read the safety regulations in particular very
carefully.

1. TECHNICAL SERVICE

A technical check-up once or twice a year helps
prolong the life of the appliance and guarantees
better operation.
Make sure that assistance is carried out solely and
exclusively by qualifi ed personnel.

2. GENERAL WARNINGS

Very important!: keep this instruction book to-
gether with the appliance for future consultation.
These warnings were drafted for your safety and
for that of others. Please read them carefully be-
fore installing or using the appliance:
• If, on receipt of the goods, the packaging is
damaged, write the following on the delivery
note: "I REVERSE THE RIGHT TO CONTROL THE
GOODS", specify the damage and get the driver
to sign in acceptance; send a claim in writing to
the seller within 4 calendar days from the date
of receipt. No claim shall be accepted after such
period.
• The warehouse inside temperature must not be
lower than -9°C; otherwise, the thermostat (reg-
ulation and safety thermostat) control devices of
the machine will be damaged. Failure to observe
this prohibition invalidates any responsibility of
the manufacturer of the machine.
• The appliance is intended for professional use
and must be utilised by qualifi ed personnel
trained to use it.
• Any modifi cation which may be necessary on the
For any spare parts orders or for any information
about the appliance, always mention the serial
number and model (data indicated on the "techni-
cal data" plate at the rear of the oven).
electrical system to enable installation of the ap-
pliance, must be carried out solely by competent
personnel.
• It is dangerous to modify or attempt to modify the
characteristics of this appliance.
• Never clean the appliance with direct water jets,
because, if any water enters, it could limit the
machine's safety.
• Before doing any maintenance or cleaning jobs,
disconnect the appliance from the electrical
mains and allow it to cool.
• When the tilting door is wide open, do not put any-
thing on the surface, because the door hinges
could be irreparably damaged.
• Do not attempt to carry out the periodic controls
or any repairs by yourself. Contact the nearest
Service Centre and use only original spare parts.
N.B.: Improper or incorrect use and failure to ob-
serve the installation instructions shall release the
manufacture from all responsibility. In this con-
nection, the directives in the "POSITIONING" par-
agraph must be strictly observed.
EN
3