Troubleshooting - Selve i-R Light Sensor Notice D'utilisation

GB

Troubleshooting

Troubleshooting
Problem
Drive is not functioning,
control light is not lit
Drive is not functioning,
control light is lit
Control light is flashing
Control light is flashing
permanently???? (leuchtet)
Control light is flashing
permanently
Roller shutter does not
move down during
sunlight hours
The i-R Light Sensor does
not execute any automatic
control commands
Cause
Batteries are dead
Batteries are
incorrectly inserted
Receiver outside the
radio range
Transmitter is not
programmed in the
receiver
Batteries are running out
TEST MODE is active
Encoding switches SUNLIGHT Check operating modes
and TWILIGHT are both
activated in TEST MODE
The i-R Light Sensor is set
to manual mode
Sun threshold value is
not exceeded
The i-R Light Sensor is set
to manual mode
36
Solution
Insert new batteries
Insert batteries correctly
Reduce distance to
the receiver
Programme transmitter
Insert new batteries
Deactivate TEST MODE
Press the manual/automatic
button repeatedly until the
control light lights up green
Adjust sun threshold value
Press the manual/automatic
button repeatedly until the
control light lights up green