Numark HDX Guide D'utilisation page 4

1. Make sure all items listed on the front of this guide were in the box.
2. READ SAFETY INSTRUCTION BOOKLET BEFORE USING THE PRODUCT.
3. Assemble unit following the Quick Assembly Instructions.
4. Study this setup diagram.
5. Place the unit in an appropriate position for operation.
6. Make sure all devices are turned off and all faders and gain knobs are set to their lowest
level.
7. Connect all stereo input sources as indicated in the diagram, your microphone, and
headphones
8. Connect the stereo outputs to power amplifier(s), tape decks, and/or other audio sources.
9. Plug all devices into AC power.
10. Switch everything on in the following order.
• audio sources (i.e. turntables or CD players)
• mixer
• finally, turn on any amplifiers or output devices
11. When turning off, always reverse this operation by,
• turning off amplifiers
• mixer
• Finally, turn off any audio sources. ALWAYS USE THE HDX'S POWER SWITCH TO
POWER OFF THE UNIT.
EXAMPLE, BY USING A POWER STRIP SWITCH).
12. Go to http://www.numark.com
More information about this product may be found at
QUICK SETUP (ENGLISH)
DO NOT SWITCH THE POWER OFF EXTERNALLY (FOR
for product registration.
2
http://www.numark.com