Festool CXS Guide D'utilisation page 13

CENTROTEC tools.
CAUTION
Tool has sharp edges and can cause cutting inju-
ries curing a tool change!

Wear protectiv gloves!
WH-CE
CENTROTEC
®
6-2 6-3 6-4
6-1
6
Attaching the CENTROTEC

Pull the release ring [6-3] forwards.

Attach the tool chuck to the drill spindle [6-4].

Release the ring [6-3].
Detaching the CENTROTEC

Pull the release ring [6-3] forwards.

Remove the tool chuck.
Changing tools

Pull back the green release ring [6-2] to attach
or detach tools with a CENTROTEC shank.

When attaching the tool, rotate until the hexa-
gon shank [6-1] engages in the hexagon holder
on the drill spindle.

Release the ring [6-2].
Chuck BF-FX 8
The chuck BF-FX 8 is used for clamping drill and
screwdriver bits up to 8 mm chuck diameter.
BF-FX 8
7-2 7-3
7-1
7
Attaching the chuck BF-FX 8

Attach the chuck to the drill spindle [7-5].

Pull the release ring [7-3] forwards.

Turn until the hexagon pin [7-4] on the chuck
engages in the hexagon socket holder in the
drill spindle.

Push the chuck all the way onto the drill spindle.

Release the ring [7-4].
Detaching the chuck BF-FX

Pull the release ring [7-4] forwards.

Remove the chuck.
Changing tools

Turn the clamping sleeve [7-2] anticlockwise to
open the clamping jaws [7-1].
 The arrow on the spindle indicates the opening
direction.

Insert the tool into the chuck.
CAUTION
Risk of injury

Clamp the tool centrally in the chuck!

Turn the clamping sleeve [7-2] clockwise to
clamp the tool.
7-4
7-5
13