Gas Connection; The Gas Distributed By A City Pipeline (Natural Gas); Bottled Gas In Tank (Butane-Propane) - Brandy Best BCGE60 Notice D'emploi

Before making the connection, make sure that the power of your electrical installation is sufficiently
dimensioned to operate your equipment safely.
In case of doubt, ask your installer, the electrical connection must be performed in accordance with standards
EN60335
The section of supply cables is very important and must be sufficient to avoid overheating and create a fire
hazard in your home.
WARNING: This device must be connected to ground via a proper outlet.
This plug must be connected to a connector complying with the standards in force at the time of installation.
WARNING : In all cases, the power cable must be positioned so that it is not in direct contact with the
hot zone. At no time the temperature close to the cable must be greater than 50 ° C.
WARNING : Place your device close enough to the power so that the connecting cable is not distended. Do
not use extension cables.

Gas Connection

The installation is usually reserved for qualified installers and technicians.
WARNING : The unit comes preset to city gas (natural gas).

The gas distributed by a city pipeline (natural gas)

The connection is made :
Either by a flexible hose with threaded mechanical connectors (fig. 1)
•
Or by a rigid connection (Copper Tubing) (fig. 2).
•

Bottled gas in tank (Butane-Propane)

The connection is made:
either by flexible hose with threaded mechanical connectors (fig. 1)
•
Or by a rigid connection (Copper Tubing) (fig. 2).
•
WARNING : as shown in Figure 3, it is forbidden to connect a hose with an end piece.
The hose must be used tightly to the standards in force at the time of installation
The flexible hose must include the different requirements:
He can not reach a temperature other than that of the highest item 30 ° C
It can not be larger than 1.5 m
It is not subject to tension or force
It can be easily inspected in order to check its condition.
24