Setting Up; Connection To The Electrical Grid - Brandy Best BCGE60 Notice D'emploi

Setting up

The installation must be performed by a competent and qualified installer in
accordance with the regulations in force at the time of installation.
Changes in domestic electric circuits may be needed to install this device and
must be made by competent persons. It is very dangerous to modify or
attempt to modify the characteristics of this device. These features are visible
on a label on the back your range.
Your device must be installed so as to have a space of 5cm and 7cm behind
on the sides and a gap of about 63.5 cm above the homes.
WARNING : This device must be placed on the ground.
IMPORTANT : Your device must be installed in an adequately ventilated area, in accordance with the
regulations in force at the time of installation.
WARNING : Avoid installation of the cooker near inflammable material (eg curtains, towels, etc.)
Completely unwind power cord and gas supply pipe as the diagram below and connect the plug.
The appliance should be positioned so that the plug is always accessible.
Do not pass electrical cables behind or near hot parts of the appliance and through the holes or covered parts
that could cut or damage the cables.
Make sure oven racks are properly inserted.

Connection to the electrical grid

This equipment is supplied without the plug, in consequence, you must install a proper outlet for the operation
of the stove
This device is designed to operate on 230V power grid with AC 50Hz, and requires a line protected by a 32A
fuse with a 6mm2 cable section.
Place the appliance
completely horizontal and far from flammable
objects. Allow a free flow of air around the device.
Height adjustment and stability of the device to the
adjustable feet at the 4 corners of the stove as
shown in the diagram
on a stable surface,
23