WAGNER G 15 Mode D'emploi page 12

Adjusting the valve rod packing
There is a hole in the cap. If coating medium is
discharged from this hole, the packing requires
adjustment.
Unscrew the cap with the spray gun wrench, then
remove the spring.
Use box spanner 10 mm to turn the pressure plate
a quarter turn to the right.
Replace the spring and tighten the cap as far as
the stop.
If the problem persists, please consult your
WAGNER service center.
Note
Do not continue to use a defective WAGNER
Airless spray gun.
Maintenance work should only be carried out by
suitably qualified, authorized personnel.
12
g
12. Spare parts list airless
spray gun G 15
(Spare parts diagram, see page 51).
Item Part no. Description
1 0335 209 Safety jet touch guard
2 ––––––– Nozzle (refer to the nozzle list)
3 0043 052* Sealing washer
4 0347 200* Intermediate piece
5 0347 308 Trigger guard
6 0347 300 Housing
7 0043 411 Cylindrical pin (2)
9 0347 312 Type plate
10 0347 701* Valve unit
12 0335 704 Pressure plate
13 0347 335 Compression spring
14 0335 301 Cap
16 0043 303* Handle seal
17 ––––––– Insert filter (refer to the table)
18 0257 312 Compression spring
19 0347 306 Handle
21 0347 708 Swivel joint M 16 x 1,5
0347 709 Swivel joint NPSM 1/4 inch – 18
23 0347 703 Trigger
24 9910 403 Cap nut M4 (2)
25 0347 310 Pin
0149 395 Gun spanner
0347 707* Service set