Removing The Front Fascia; Installing An Odd; Installing Ssds And Hdds; Installing A Second Front Fan - Corsair CARBIDE Série Guide D'installation

SPEC-01

5. Removing the Front Fascia

To remove the front fascia
(front panel), grasp the tab
located at the bottom fascia
and pull outward.
STEP 06
STEP 06
6. Installing an ODD (Optical Disk Drive)
First, remove the front panel
5.25" drive bay cover then
slide the ODD into the drive
bay until the tool-free latch
clicks, securing the drive. To
release an optical drive, push
in the tool-free tab then pull
the drive outward.
7
First
Second
STEP 07

7. Installing SSDs and HDDs

The four included drive trays
support both 3.5" and 2.5"
devices.
To install a 3.5" HDD, pull the
drive tray from each side to
extend the mounting points.
Next, place your HDD onto
the tray and push the drive
back to a close. No screws are
necessary to secure the drive
onto the tray.
STEP 08
To install a 2.5" SSD, place the
drive on the tray and use the
provided screws to install
c
the SSD.

8. Installing a Second Front Fan

To install an additional 120mm
or 140mm fan, remove the
front fascia (step 5) then use
the provided long fan screws
f
to mount the new fan.
Note: To maximize airflow you
may install either x2 120mm or
x2 140mm fans in the front of the
chassis.
8