Removing The Front Fascia; Installing An Odd; Installing Ssds And Hdds; Installing A Second Front Fan - Corsair CARBIDE Série 100R SILENT EDITION Guide D'installation

CARBIDE SERIES
®

5. Removing the Front Fascia

To remove the front fascia
(front panel), grasp the tab
located at the bottom fascia
and pull outward.
6. Installing an ODD (Optical Disk Drive)
First, remove the front panel
5.25" drive bay cover then
slide the ODD into the drive
bay until the tool-free latch
clicks, securing the drive. To
release an optical drive, push
in the tool-free tab then pull
the drive outward.
100R Silent STEP5
7
100R SILENT EDITION
Second

7. Installing SSDs and HDDs

The four included drive
trays support both 3.5"
and 2.5" devices.
To install a 3.5" HDD, pull the
drive tray from each side to
extend the mounting points.
Next, place your HDD onto
the tray and push the drive
back to a close. No screws are
necessary to secure the drive
onto the tray.
To install a 2.5" SSD, place the
drive on the tray and use the
provided screws
the SSD.

8. Installing a Second Front Fan

To install an additional 120mm
or 140mm fan, remove the
front fascia (step 5) then use
the provided long fan screws
to mount the new fan.
Note: To maximize airflow you may
install either x2 120mm or x2 140mm
fans in the front of the chassis.
First
100R Step7
100R Silent Step 8
to install
c
f
8