Reassembling After Cleaning; Troubleshooting - Brandt FRI2202E Manuel D'instruction

Remove all the food residues from the tank and basket using kitchen towel. Wash the parts by
hand in hot soapy water. Rub using a sponge. Dry the basket completely before putting it
away.
Cleaning the control unit, the other parts and the body
These parts are not dishwasher-proof.
Wipe the surplus oil off the element with kitchen towel (take care not to damage the electric
wires connected to the heating element). Wipe the control unit and the body with a clean cloth,
either very slightly damp or dry.
c)

Reassembling after Cleaning

 Place the machine body on a stable, safe, dry, horizontal surface.
 Hold the edge of the frying tank on both sides to lower it into the fryer.
 Reconnect the control unit to the body. The control unit has two rails into which the
corresponding parts should be inserted in the body of the fryer.
 Slide the setting panel downwards into the rails (Figure B) until the elements are correctly
assembled and inserted into the slits.
Note: The fryer will not work if the control unit is not attached to the body.
If you use the fryer, lift the frying basket handle and then put it back in the locking position.
Make sure the handle is firmly fixed on the body.
To store the fryer, replace the basket, fold back the handle and close the lid.
d) Troubleshooting
This machine is manufactured in accordance with the highest safety standards. Follow these
steps if the machine does not work:
 Check that you have followed the instructions in the manual properly.
 Check that the fuse has not tripped.
 Check that the wall socket is working properly.
BRANDT FRANCE - Simplified Joint Stock Company with capital of 1,000,000 Euros
89/91 Boulevard Franklin Roosevelt - 92854 Rueil-Malmaison (France)
26