Operating - EUROM Orsa Manuel D'utilisation

3. Place the metal plate with the 4 holes on the
inside of the wood compartment. Place the 4
screws through the holes of the metal plate.
Screw the wing nuts firmly onto the screws and
set the heater upright.
 Completely unwind the electrical cable and insert the plug into a suitable 220-240V
earthed socket. To prevent overloading, check that no other equipment is connected to
the same group.

Operating

 Check that the details on the data plate correspond to those of the electrical supply
which you wish to use for the fireplace. Do not use the same connection for any other
equipment.
 The control switches and the thermostat knob are located at the rear of the heater.
 By pressing the bottom switches you will make the following happen:
Switch 1:
Switches 1+2: switch on 1000 Watt heating, with flame effect
Switches 1+2+3:
switch on the power supply to the heater and the flame
effect (without heating) (O depressed is OFF - I depressed
is ON).
switch on 2000 Watt heating, with flame effect
31