GreenWorks Tools 2600007 Manuel D'utilisation page 6

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
• The authorized service workshops only use genuine spare parts. Genuine spare parts and accessories have been
designed specifically for machines.
• Non-genuine spare parts and accessories are not approved. Use of non-genuine spare parts and accessories
cause the warranty to expire.
• It is advisable to send your machine once a year to an authorized service workshop for servicing, assistance and
safety device inspection.
PROBLEM
No start
The motor barely rotates.
The motor stops
suddenly
Excessive vibrations
Loss or slowing of
thrown snow
The snow thrower
leaves a light layer of
snow on the ground.
English (original instructions)
TROUBLESHOOTING
PROBABLE CAUSE
Battery is not inserted or is inserted
incorrectly.
Overload protection activated
The auger is on and the motor
cannot start.
Auger or discharge chute
obstructed, blocked by obstacles
or damaged.
The capacitor is faulty.
Electric part malfunction
Overload protection activated
Loose parts or auger or rotor
damaged.
Handle not correctly positioned.
Blocked discharge chute.
Auger blocked.
Auger blade worn.
SOLUTION
Check that the battery is correctly
inserted.
Wait a few seconds for automatic reset.
Immediately release the start control and
remove the obstacle. Try and switch on
again.
Clean the auger and chute. Remove
any dirt or foreign bodies. Replace if
damaged.
Call assistance or the dealer.
Call assistance or the dealer.
Wait 10 minutes and try again.
Tighten all the fastening devices.
Replace the damaged parts in the
authorised assistance centre.
Ensure the handle is fastened in its
position.
Clean the discharge chute.
Remove any dirt or foreign bodies from
the auger.
Contact the authorised assistance
centre.
5