Packing List - GreenWorks Tools 2600007 Manuel D'utilisation

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
ASSEMBLY
UNPACKING
This product requires assembly.
„ Carefully remove the product and any accessories
from the box. Make sure that all items listed in the
packing list are included.
Do not use this product if any parts on the Packing
List are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer
installation. Use of a product that may have been im-
properly assembled could result in serious personal
injury.
„ Inspect the product carefully to make sure no
breakage or damage occurred during shipping.
„ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
„ If any parts are damaged or missing, please call your
Greenworks Tools service centre for assistance.

PACKING LIST

„ Snow thrower
„ Upper chute control rod
„ Lower chute control rod
„ Middle handle assembly
„ Chute deflector
„ Cam locks
„ Bolts
„ Handle knobs
„ Spring pin
„ Ignition key
„ Owner's Manual
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of this
product with damaged or missing parts could result
in serious personal injury.
English (original instructions)
WARNING
WARNING
Do not attempt to modify this product or create ac-
cessories not recommended for use with this prod-
uct. Any such alteration or modification is misuse and
could result in a hazardous condition leading to pos-
sible serious personal injury.
To prevent accidental starting that could cause seri-
ous personal injury, always remove the battery pack
from the product when assembling parts.
HANDLE ASSEMBLY (See figure 4)
„ Remove the battery pack.
„ Align the holes on the middle handle and the lower
handle. Insert the bolts, and use the handle knobs
to tighten them.
„ Align the hole on the middle handle and the upper
handle. Insert the cam locks and tighten them with
the handle knobs provided. Once tightened, close
the cam locks to secure them in place.
Note: If the upper handle is loose or separated from the
middle handle, tighten the cam lock handle knobs by
turning them clockwise. Do not overtighten the handle
knobs.
DISCHARGE CHUTE ADJUSTMENT HANDLE AS-
SEMBLY (See figure 5-6)
„ Align the holes on the upper chute control rod with
the holes on the lower chute control rod.
„ Insert the spring pin in the hole and fasten.
„ Insert the end of the chute control rod through the
keyed hole in the bracket that is attached to the top
of the middle handle.
„ Insert the end of the handle in the specific coupling
hole on the chute, keeping it straight and with the
grip upwards.
„ Check the discharge chute by turning it entirely in
both directions. The chute must freely rotate.
DEFLECTOR ASSEMBLY (See figure 7)
„ Push the chute deflector until the latching tabs on
both sides click into the slots and the posts on both
sides click into the keyed holes.
2
WARNING
WARNING