GreenWorks Tools 2600007 Manuel D'utilisation page 5

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
Wet or compact snow
Slowly move forward. Avoid using the lower blade to
remove compact snow and ice.
IMPORTANT: Heavy use of the machine with wet or
compact snow can cause faults to the auger compart-
ment.
AFTER OPERATION
„ Immediately remove
compartment.
„ Clean the remaining snow on the machine with a
brush.
„ Move all the controls forward and back a few times.
„ Tighten any nuts and bolts that are loosened during
operation.
„ Check there are no loose or damaged components.
If necessary, replace the damaged components.
Do not cover the machine when the motor is still
warm.
DEFLECTOR ADJUSTMENT (See figure 10)
„ To adjust the discharge chute, rotate the chute
adjustment handle in the direction that you wish to
direct the snow stream.
„ To adjust the chute deflector (and therefore the
height of the snow stream), squeeze the trigger and
raise or lower the chute deflector.
MAINTENANCE
All service and all maintenance checks must be
carried out on a stationary machine with the motor
switched off. Before any maintenance operation,
switch off the motor and remove the key from the
compartment.
Wear adequate clothing, gloves and goggles before
carrying out any maintenance.
„ The use of non-genuine spare parts and accessories
could adversely affect machine operation and
safety. The manufacturer shall decline all liability in
the event of injuries or damages caused by such
parts.
„ Genuine spare parts are supplied by authorized
assistance workshops and dealers.
English (original instructions)
the battery
WARNING
WARNING
WARNING
IMPORTANT: All the maintenance and adjustment op-
erations not described herein must be carried out by
your dealer or Authorised Service Centre.
CLEANING
Carry out cleaning operations with the machine
switched off. Do not try to remove snow from the dis-
from its
charge without firstly:
• Releasing the auger control.
• Removing the ignition key.
• Removing the battery.
Always clean the machine after use.
To clean the machine adhere to the instructions pro-
vided below:
„ Stop the motor.
„ Remove the battery from its compartment.
„ Cool the snow thrower.
„ Clean the snow thrower internally and externally
with an adequate brush and/or compressed air.
Never wash the snow thrower with water, otherwise
the electric device will be damaged causing the risk
of electrocution.
STORAGE
If you intend to put your machine away for more than
30 days:
„ Clean the snow thrower thoroughly.
„ Check for any damage. If necessary, see to the
necessary repairs.
„ If the paintwork is damaged, touch it up to prevent
rust.
„ Protect any exposed metal surfaces from rust.
ASSISTANCE AND REPAIRS
This manual provides all the necessary information to
run the machine and for correct basic maintenance
operations which can be performed by the user. Any
regulations and maintenance operations not described
herein must be carried out by your Dealer or Authorized
Service Centre, which have the necessary knowledge
and equipment to ensure that the work is carried out
correctly, maintaining the correct degree of safety and
the original operating conditions of the machine. Any
operations performed in unauthorized centres or by
persons will totally invalidate the Warranty and all obli-
gations and responsibilities of the Manufacturer.
• Only authorized service workshops can carry out
guaranteed repairs and maintenance.
4
WARNING
WARNING