Maintenance Of The Spa; Renewing The Water Of The Spa; Maintenance Of Cartridge Filters; Maintenance Of The Surface - GRE SPA 4000 Manuel De Fonctionnement

UTILIZATION MANUAL
6. MAINTENANCE INSTRUCTIONS OF
THE SPA
Spas are built with maximum quality and with the
hardest wearing materials available. Proper care and
maintenance will ensure a long life span of the Spa
and its components.

6.1 RENEWING THE WATER OF THE SPA

To change the water of the Spa:
• Disconnect the electrical equipment.
• Locate the drain valve and turn left to the OPEN
position. The Spa will empty by gravity through
the general drain.
•
Once the Spa is empty, inspect the acrylic and
clean if necessary. Turn the drain valve to the
CLOSED position.
• Fill in the Spa with clean water (see "Filling the
Spa").
6.2. MAINTENANCE
FILTERS.
The Spa has a water filtering system through cartridge
filters.
It is advisable to periodically check the
condition of the cartridge filter. Clean them
or substitute them if dirt is observed.
Remember that if a filter is blocked, it will
reduce the water flow and therefore, the Spa
will operate incorrectly.
To change or clean the filter:
1. Disconnect the electrical equipment.
2. Remove the cover.
3. Remove the filtering cartridge vertically making
half a turn in order to facilitate the exit by
pressure relief and without hard movements, this
way the particles that are in the filter will not fall
down into the water of the Spa.
4. Clean the filtering cartridge with a garden hose jet
spray at low pressure until it is clean. Clean from
top to bottom spraying the water at an angle of
45º.
OF THE CARTRIDGE
5. After several washing cycles, it may be necessary
to change the filtering cartridge.
The filtering
Contact your supplier or specialist shop.
6. Replace the filtering cartridge and its cover.
7. Turn on the electrical equipment.
The Spa should always operate with the
filtering cartridge in the correct position.
Never place objects that could block the
filter.

6.3. MAINTENANCE OF THE SURFACE

To clean the polyethylene surface, use a non-abrasive
cleaner and hot water. Once the Spa is clean, rinse
with water to remove the detergent.
Remember never to leave the Spa uncovered
and exposed to sunlight as this could cause
damage not covered by the guarantee.

6.4. MAINTENANCE OF THE SPOTLIGHT

A black ABS plastic spanner is provided to dismantle
the projector.
Changing the lamp is the only maintenance required
on the spotlight. To replace the lamp, follow these
steps:
9
cartridge code is
EN
AR880.