Using The Water Flow Control Valve; Turning The Light On And Off; Standard - Economic -Sleep Modes; Filtering Cycles - GRE SPA 4000 Manuel De Fonctionnement

UTILIZATION MANUAL
ATTENTION!
Do not to forcibly turn the outer ring of the
jet, as you could damage it.

5.5. USING THE WATER FLOW CONTROL VALVE

The water flow from the different seats of the Spa can
be regulated by using the control valve allowing
greater or lesser water flow depending on the type of
massage required.
The diagram below shows the water distribution
depending on the position of the valve.

5.6. TURNING THE LIGHT ON AND OFF

To turn the light on and off, press
control panel.
The light will automatically disconnect after 4 hours.
5.7. STANDARD – ECONOMIC - SLEEP MODE
The mode is necessary to personalize and/or choose
the best functioning depending on our preferences.
Press "TEMP" and "LIGHT" to change the mode.
Standard Mode
It is programmed to maintain the wanted temperature.
Attention: On screen we will see the temperature of
the last time that the filtering pump was working for at
least 2 minutes.
When changing to standard, the message "
on screen.
Economic Mode
The Spa water is heated only within the filtering
cycles.
The
temperature is not the current one. In the event the
temperature of the water from the Spa gets the
required temperature, the message "
with the temperature number.
Sleep Mode
This mode heats the water from the Spa 10ºC under
the programmed temperature and only during the

filtering cycles.

Drain outlet
(no jet)
5.8. FILTERING CYCLES
The Spa has a filtering system for the solid impurities
of water. Water is collected by the filtering cartridge,
going through the filtering pump and the heat
exchanger, and returns into the Spa through 1
impulsion nozzle.
The first filtering cycle starts 6 minutes after the Spa is
Light
from the
connected to the power supply.
The second filtering cycle starts 12 hours later.
The length of the filtering cycle can be programmed
for 2, 4, 6 8 hours or continuous filtering (24 hours)
6
ATTENTION! - Do not turn on the light when
the Spa is empty of water. The lamp will fuse
through lack of refrigeration.
+
message " " will
Ec
EN
" is seen
SE
be shown when the
" will be shown
Ec