TRANSFERRING DATA FROM YOUR WATCH TO THE APP
Your TIMEX IRONMAN Classic 50 Move+ offers a discrete connection to the TIMEX Connected app. This
means your watch must be manually synced with the app each time you want to transfer data between
the app and the watch.
To transfer data using Bluetooth Smart:
1. From the Home Page, tap the watch icon in the upper right-hand corner.
2. On the watch, push the Mode button until you see "SYNC PHONE/PRESS START" on the screen.
3. Push the Start/Split button on the watch and then tap the Sync button on the app.
4. In the app pop-up window, select Keep Watch Settings or Keep App Settings.
Keep Watch Settings should be used if you want to maintain any settings adjusted on
the physical watch face.
Keep App Settings should be used if you want to maintain any settings adjusted in the
app.
5.
"SYNC OK" will be displayed on the watch, "Sync Complete" will be displayed on the app and
your data sync was successful.
To transfer data using NFC:
1. Hover your Classic 50 Move+ around the back of your Android device; remember the watch has
to be very close to the NFC antenna to connect.
If the TIMEX Connected app is not open, the first touch of the watch to the mobile
device will open the app.
2. A pairing window will appear and the watch will create an audible tone, do not move the watch
from that location until the status bar on the app fills in (which signifies the connection is
established).
3. In the 'Synchronize' pop-up window, select Keep Watch Settings or Keep App Settings.
Keep Watch Settings should be used if you want to maintain any settings adjusted on
the physical watch face.
Keep App Settings should be used if you want to maintain any settings adjusted in the
app.
4. If Keep App Settings is selected, you will need to touch the watch to the back plate of your
Android device.
5. The Home page of the app will be displayed and the Last Sync data should be updated to the
current time and date.
®
®
TIMEX
IRONMAN
Classic 50 Move+ Owner's Manual
Page 18