RIDGID R4513 Manuel D'utilisation page 47

TROUBLESHOOTING
Problem
Saw does not make 0˚ or 45˚ cuts.
Height Adjusting Knob is hard to turn.
Saw does not start.
Blade makes poor cuts.
Motor overheats.
Motor labors in rip cut.
Cause
Bevel stops not properly adjusted.
Miter gauge is misaligned (Miter Cuts).
Gears or screw post inside cabinet are
clogged with sawdust.
Handwheel is locked.
Power cord not plugged in.
Circuit fuse is blown.
Circuit breaker is tripped.
Cord, switch, or motor is damaged.
Blade is dull or dirty.
Blade is wrong type for cut being made.
Blade is mounted backwards.
Work is fed too fast; motor overloaded. Feed work slower into the blade.
Blade not proper for rip cut.
47 − English
Solution
See To Set the Bevel Indicator and
Bevel Stops at 0˚ and 45˚ (Squaring
the Blade) in the Adjustments section.
See To Adjust the Miter Gauge in the
Adjustments section.
Clean the gears or screw posts.
Unlock the blade height lock knob by
pushing the bevel lock lever to the right.
Plug in power cord.
Replace circuit fuse.
Reset circuit breaker.
Have replaced by qualified service
center.
Clean, sharpen, or replace blade.
Replace with correct type.
Remount blade.
Change blade; rip blade typically has
fewer teeth.