Front Or Rear Discharge Installation - Hatco Toast-Qwik TQ-10 Série Manuel D'installation Et D'utilisation

English

Front or Rear Discharge Installation

Toast-Qwik units can be set up so toasted product discharges
at either the front or the rear of the unit.
WARNING
FIRE HAZARD:
• For front discharge operation: Allow a minimum
clearance of 1" (25 mm) along the sides and rear of
unit. Allow a minimum clearance of 12" (305 mm) in the
front. If safe distances are not maintained, discoloration
or combustion could occur.
• For rear discharge operation: Allow a minimum
clearance of 1" (25 mm) along the sides of unit. Allow
a minimum clearance of 12" (305 mm) in the front and
rear. If safe distances are not maintained, discoloration
or combustion could occur.
Model TQ-10
Model TQ-10 uses a one piece discharge chute/collector pan.
The installation location determines the discharge area.
For front discharge:
• Slide the toaster chute into the toaster from the front of the
toaster with the rear lip of the chute on the rear most pins.
Rear
Pin
TQ-10 Front Discharge
For rear discharge:
• Slide the toaster chute into the toaster from the rear of the
toaster with the lip of the chute over the inside set of pins.
TQ-10 Rear Discharge
Form No. TQ2M-1121
TQ-400, -800, -1200, and -1800 Series
TQ-400, -800, -1200, and -1800 series toasters use a separate
discharge chute and toast collector pan. The installation
location determines the discharge area.
For front discharge:
1. Install the discharge chute.
2. Position the toast collector pan, with the open end in first,
For rear discharge:
1. Remove the discharge chute if it is installed. It is not used
2. Slide the toast collector pan, with the open end first, over
Pin
11
• Place the curved end inward until the rear lip of the
chute is on the rear chute pins.
• Lower the front slots of the chute onto the front chute
pins.
over the pan pins.
• Align the slanted notches over the pan pins and lower
into place.
Discharge Chute
Toast Collector Pan
TQ-400, -800, -1200, and -1800 Series Front Discharge
for rear discharge.
the set of pan pins at the rear of the unit.
• Align the slanted notches over the two sets of rear pan
pins and lower into place.
Rear
Pan Pins
Toast Collector Pan
TQ-400, -800, -1200, and -1800 Series Rear Discharge
INSTALLATION
Rear Chute
Pin
Front Chute Front Chute Front Chute
Pin Pin Pin
Pan
Pins