Assembly Preparation - Güde BIG WHEELER 508 VARI-S Mode D'emploi Original

Add fuel outdoor only, do not smoke when adding
o
fuel.
Add fuel before device starting. Never take the
o
cover out and do not add fuel when the engine is
running or hot.
- If you spill the petrol do not try to start the device.
o
Take the device away and prevent generation of a
flammable source around the spilled petrol.
Secure the petrol tank is closed safely.
o

Always check whether the knife, knife bolts and cutting
equipment are not damaged or worn before using the
mower. Always replace any damaged and worn knives
and bolts in the entire set to prevent device unbalance.
Do not make any alterations to the safety device.
Regularly check their proper functioning.

Keep the device clean, with no grass, leaves or other
impurities. Always wipe any oil or petrol run out. Let the
mower cool down before storing to closed spaces.

Be especially careful when changing direction on a
slope.

Never adjust the height of wheels when the engine is
running.

The grass catching device may lose its functioning any
throw away items due to wear or damage. Regularly
check the mower parts and, if necessary, replace them
with spare parts recommended by the manufacturer.

The mower knife is very sharp. Risk of injury! Be
especially careful at knife maintaining, wear protective
gloves or cover the knife-edges.

Do not change the basic engine adjustment and avoid
its overloading.

Be especially watchful when turning the mower or
pulling it towards your body.

If it is necessary to incline or lift the mower to pass a
surface other than grass or when carrying the mower to
or from the area to be cut then cut off the knife.

Release the knives and engine clutches before
switching on.

Start the engine in accordance with the operating
instructions and make sure your legs are in safe
distance from the knife.

Do not incline the mower at starting except for cases
when it is necessary. Do not incline the mower more
than necessary in such a case and always lift the part
reversed from you.

Do not start the engine when standing in front of the
ejection outlet.

Never lift and transfer the mower with engine running.

Lower the brake adjustment when the engine is off. If
the engine is equipped with a stop valve then close the
petrol supply after cutting.

Move slowly if using an auxiliary trail seat.
ASSEMBLY / PREPARATION
All assembly and/or maintenance works may be
performed only when the motor is turned off!
Please read the entire operating instructions before
assembling or starting your new mower.
IMPORTANT: The mower is supplied without oil and
petrol.
UNPACK THE MOWER
Take the mower out of the board and check whether there
are any free parts left there.
Wheel assembly (Fig. 2 a-f)
Install wheel at the lawn mower according to figures 2 a-f.
Pay attention to proper order of spacer disc at both
sides (fig. 2d)
Pay attention to that star-shaped screws are tightened
firmly enough (self-locking.
Assembly of collecting bag
Take the grass catcher out of the package and fit it to the
appropriate frame according to the picture.
Assembly - Handle
IMPORTANT: Disassemble the handle with care to prevent
clamping or damage of the cables.
1. Lift the handle until it snaps in the working
position.
2. Remove the protection sleeve, lift the upper parts of the
handle and assemble it with the bottom part. Tighten
the safety bolts on both sides of the handle.
3. Remove the protection sleeve of the operation grab handle in
the upper part.
Operation
Operation lever (for automatic stopping) (12) – press
the lever towards the handle when starting. If you want to
switch the engine off release the lever.
Gas lever (2) – used at starting
Drive lever (13) - used when you want the mower to be
moving forward.
loslassen = release
nach oben drücken = push up
13