First Time Usage; Horizontal Alignment - Futech GYRO GS Mode D'emploi

First time usage

• Remove all protection foils.
EN
• The batteries in the device are only partially charged. We recommend charging the
batteries completely before first usage of the device.
•
The device has to be charged with the supplied power adapter/charger. Plug in the
adaptor in the connector (5).
• The LED on the power adapter indicates 3 different options:
Red blinking LED: The battery is not charging.
Red LED: The battery is charging.
Green LED: The battery is fully charged.
•
When fully charged, the device can operate during approximately 20 hours. Fully
charging the battery takes circa 7 hours.

Horizontal alignment

•
Please install the device on a solid surface. Usage of a tripod is recommended. You can
fix the laser device on the tripod with the 5/8" bold (7) on the bottom of the device.
•
Switch on the device with power button (9).
•
After switching on the device, the built servomotors will start the automatic leveling.
These motors can level out the device within a range of 5°. Please make sure the
device is not tilted more than 5°. As soon as the device is leveled, the laser head (8)
will start spinning.
•
When using the device outside, the laser beam will only be visible with the help of the
receiver supplied with your rotary laser.
•
If the device is tilted more than 5°, the laser beam will keep blinking. Reposition the
device so it is put flat (= tilted less than 5°).
44 Gyro GS
www.laseto.be