Futech GYRO GS Mode D'emploi page 45

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Set a digital slope
Install the device horizontally flat as explained under "Horizontal alignment".
Press the digital slope button (12). The X-axis on the display starts blinking.
Set the desired slope for the X-axis with the arrow buttons up (13) and down (14).
(The X-axis is indicated on top of the device. It's the axis in parallel with the display.)
The selected slope appears on the display.
Push the X/Y selector (11) to switch to the Y-axis.
Set the desired slope for the Y-axis with the arrow buttons up (13) and down (14).
(The Y-axis is indicated on top of the device. It's the axis perpendicular to the
display.) The selected slope appears on the display.
Push the X/Y selector (11) again to confirm the selected slopes.
In case the device has been moved or hit during this process, the device will alert
you with a beep-signal. An explanation mark will be displayed. In this situation,
always fully restart setting the slope to avoid errors when measuring.
Set a manual slope
Install the device horizontally flat as explained under "Horizontal alignment".
Hold the power button (9) during 3 seconds until the XXX appears on the display.
(Please note this function is not available via the remote control. It can only be
activated with the power button (9) on the device itself.)
Push the X/Y selector (11) to select the axis where you need to set the slope.
Set the desired slope for the selected axis with the arrow buttons up (13) and down
(14).
EN
GYRO GS
45

Publicité

Table des Matières
loading

Table des Matières