First Steps; Horizontal Alignment; Hold Function - Futech RED RACER Mode D'emploi

First steps

EN
•
Remove any protective films where applied.
•
Press the on/off button (5) , and the instrument will align itself on its own. Make
sure that the instrument is not on too much of a slope (within 5°). If the slope of
the instrument should exceed 5°, the lasers will flash automatically.
•
Preferably use a stable surface, or use a tripod to obtain the propper alignment.

Horizontal alignment

• Press the on/off button (5), and provide the instrument is within its levelling
range, the horizontal line will be automatically leveled.
•
The horizontal line can be activated or deactivated using the "H" button (10).
•
If possible, it is recommended that the horizontal line should be placed at
working height. This will improve the work quality.
• NB: cross line lasers can only be used on tripods which are adjustable in height,
such as cranked or telescopic tripods.
•
Before using a tripod, you can remove the base (8). Choose only tripods with 5/8"
fillet.
• If the workplace is very brightly lit, e.g. out of doors, it may be necessary to use
the laser receiver.

Hold Function

•
Press the "hold" button (6) on the keypad to activate the "hold" function.
• As soon as the alignment is interrupted, the laser stops turning, and the LED
above the "hold" button (6) starts flashing.
•
If this happens, you need to re-align the laser on the correct height.
•
Press the "hold" button (6) again, to deactivate the "hold" function.
•
If you want to reactivate the "hold" function, you need to repeat these steps.
40 Red Racer
www.laseto.be